Fire-lite MMF-300 Monitor Module Bedienungsanleitung PDF herunterladen

Figure 2.

Module mounting:

Before Installing

This information is included as a quick reference installation guide. Refer to the control panel installation manual for detailed system

information. If the modules will be installed in an existing operational system, inform the operator and local authority that the system

will be temporarily out of service. Disconnect power to the control panel before installing the modules.

NOTICE: This manual should be left with the owner/user of this equipment.

General Description

The MMF-300 Monitor Module is intended for use in addressable, two-wire systems, where the individual address of each module is se-

lected using the built-in rotary switches. It provides either a 2-wire or 4-wire fault tolerant Initiating Device Circuit (IDC) for normally open

contact fire alarm or supervisory devices. The module has a panel controlled LED indicator. The MMF-300 can be used to replace an

M300 module in existing systems.

Compatibility Requirements

To ensure proper operation, these modules shall be connected to listed compatible system control panels only.

Mounting

The MMF-300 mounts directly to 4” square electrical boxes (see Figure 2). The box must have a minimum depth of 2

”. Surface

mounted electrical boxes (SMB500) are available.

Wiring

NOTE:

All wiring must conform to applicable local codes, ordinances, and regulations. This module is intended for power limited wiring only.

1. Install module wiring in accordance with the job drawings and appropriate wiring diagrams.

2. Set the address on the module per job drawings.

NOTE: Some panels support extended addressing. In order to set the module above address 99 on Fire•Lite compatible systems,

carefully remove the stop on the upper rotary switch with thumb in the direction shown in Figure 1.

3. Secure module to electrical box (supplied by installer), as shown in Figure 2.

Specifications

Normal Operating Voltage: 15 to 32 VDC

EOL Resistance: 47K Ohms

Maximum IDC Resistance: 1,500 Ohms

Temperature Range: 32˚F to 120˚F (0˚C to 49˚C)

Humidity: 10% to 93% Noncondensing

Dimensions: 4

” H x 4” W x 1

” D (Mounts to a 4” square by 2

/8” deep box.)

Accessories: SMB500 Electrical Box

MMF-300 Monitor Module

Installation Instructions

Figure 1. Controls and indicators:

F300-02-00 1 I56-1191-01

Fire•Lite Alarms, Inc., One Fire-Lite Place., Northford, CT 06472, 203-484-7161

TENS

ONES

ADDRESS

LOOP

A78-2318-07

A78-2610-10

1 2

Inhaltsverzeichnis

Seite 1 - Installation Instructions

Figure 2.Module mounting:9876543210ADDRESS00123456789TENSONES786543219101112131415Before InstallingThis information is included as a quick reference i

Figure 3. Typical 2-wire Initiating Device Circuit (IDC) configuration, NFPA Style B (Class B):Figure 4. Typical 4-wire fault tolerant Initiating Devi

Kommentare zu diesen Handbüchern

Keine Kommentare

Fire-lite MMF-300 Monitor Module Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Ausrüstung Fire-lite MMF-300 Monitor Module herunter. Fire-Lite MMF-300 Monitor Module User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Fire-lite MMF-300 Monitor Module